Week 3

31/1/2012


Do the programming introduction the Verilog Design using Quartus 2 software. It gives a general overview of the typical CAD flow for designing circuit that are implemented by using FPGA devices. The Quartus II system includes full support for all of the popular methods of entering a description of the desired circuit into a CAD system. 

This programming makes use of the Verilog design entry method, in which the user

specifies the desired circuit in the Verilog hardware description language. Two other versions of this programming are also available:

1.  Uses the VHDL hardware description language
2.  The other is based on defining the desired circuit in the form of a schematic diagram.

1/2/2012

The last step in the programming introduction the Verilog Design using Quartus 2  process is involves configuring the designed circuit in an actual FPGA device. To show how this is done, it is assumed that the user has access to the Altera DE2 Development and Education board connected to a computer that has Quartus II software installed.

The objective do the simple programming are:

• To creating a project
• To entering a schematic diagram
• To synthesizing a circuit from the schematic diagram
• To fitting a synthesized circuit into an Altera FPGA
• To assigning the circuit input and output to specific pins on the FPGA
• To simulating the designed circuit
• To programming and configuring the FPGA chip on Altera DE2 board

2/2/2012

Meet supervisor Madam Norhaslinawati Binti Ramli.

The objective are:

• To discuss the progress of project.
• To discuss with supervisor about the programming.
• To discuss with supervisor the problem about hardware.